Edge-Core ECS4810-12M Layer 2 Management Manual page 468

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| Basic Administration Protocols

Connectivity Fault Management

All MEPs that exist on other devices inside a maintenance association

should be statically configured to ensure full connectivity through the

cross-check process.

Remote MEPs can only be configured if local domain service access

points (DSAPs) have already been created (see

Maintenance End

Points") at the same maintenance level and in the

same MA. DSAPs are MEPs that exist on the edge of the domain, and

act as primary service access points for end-to-end cross-check, loop-

back, and link-trace functions.

The MEP cross-check start delay which sets the maximum delay that a

device waits for remote MEPs to come up before starting the cross-

check operation can be configured on the Configure Global page (see

"Configuring Global Settings for

SNMP traps for continuity check events discovered by cross-check

operations can also be configured on the Configure Global page (see

"Configuring Global Settings for

These parameters are displayed:

MD Index – Domain index. (Range: 1-65535)

MA Index – MA identifier. (Range: 0-4094)

MEP ID – Identifier for a maintenance end point which exists on

another CFM-enabled device within the same MA. (Range: 1-8191)

To configure a remote maintenance end point:

Click Administration, CFM.

Select Configure Remote MEP from the Step list.

Select Add from the Action list.

Select an entry from MD Index and MA Index.

Specify the remote MEPs which exist on other devices within the same

Click Apply.

"Configuring

Troubleshooting