Mac Acls; Access-List Mac; Permit, Deny; Table 93: Mac Acl Commands - Edge-Core ECS4810-12M Layer 2 Management Manual

| Access Control Lists
C 27
HAPTER

MAC ACLs

MAC ACL
S

access-list mac

The commands in this section configure ACLs based on hardware
addresses, packet format, and Ethernet type. To configure MAC ACLs, first
create an access list containing the required permit or deny rules, and then
bind the access list to one or more ports.

Table 93: MAC ACL Commands

Command Function
access-list mac Creates a MAC ACL and enters configuration mode

permit, deny

Filters packets matching a specified source and
destination address, packet format, and Ethernet type
mac access-group Binds a MAC ACL to a port
show mac access-group Shows port assignments for MAC ACLs
show mac access-list Displays the rules for configured MAC ACLs
This command adds a MAC access list and enters MAC ACL configuration
mode. Use the no form to remove the specified ACL.
S
YNTAX
[no] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters, no
spaces or other special characters)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
◆ When you create a new ACL or enter configuration mode for an existing
ACL, use the permit or deny command to add new rules to the bottom
of the list.
To remove a rule, use the no permit or no deny command followed by
◆
the exact text of a previously configured rule.
An ACL can contain up to 128 rules.
◆
E
XAMPLE
Console(config)#access-list mac jerry
Console(config-mac-acl)#
– 806 –
Mode
GC
MAC-ACL
IC
PE
PE