Configuring By Port Range - Edge-Core ECS4810-12M Layer 2 Management Manual

| Interface Configuration
C 5
HAPTER
Port Configuration
C
ONFIGURING BY
P R
ORT ANGE
W I
EB NTERFACE
To configure port connection parameters:
Click Interface, Port, General.
1.
Select Configure by Port List from the Action List.
2.
Modify the required interface settings.
3.
Click Apply.
4.
Figure 24: Configuring Connections by Port List
Use the Interface > Port > General (Configure by Port Range) page to
enable/disable an interface, set auto-negotiation and the interface
capabilities to advertise, or manually fix the speed, duplex mode, and flow
control.
For more information on command usage and a description of the
parameters, refer to "Configuring by Port List" on page
CLI R
EFERENCES
"Interface Commands" on page 817
◆
W I
EB NTERFACE
To configure port connection parameters:
Click Interface, Port, General.
1.
Select Configure by Port Range from the Action List.
2.
Enter to range of ports to which your configuration changes apply.
3.
Modify the required interface settings.
4.
– 134 –
132.