Dot1X Timeout Supp-Timeout; Dot1X Timeout Tx-Period - Edge-Core ECS4810-12M Layer 2 Management Manual

| Authentication Commands
C 25
HAPTER
802.1X Port Authentication
dot1x timeout supp-
timeout
dot1x timeout tx-
period
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout re-authperiod 300
Console(config-if)#
This command sets the time that an interface on the switch waits for a
response to an EAP request from a client before re-transmitting an EAP
packet. Use the no form to reset to the default value.
S
YNTAX
dot1x timeout supp-timeout seconds
no dot1x timeout supp-timeout
seconds - The number of seconds. (Range: 1-65535)
D
EFAULT
30 seconds
C M
OMMAND ODE
Interface Configuration
C U
OMMAND SAGE
This command sets the timeout for EAP-request frames other than EAP-
request/identity frames. If dot1x authentication is enabled on a port, the
switch will initiate authentication when the port link state comes up. It will
send an EAP-request/identity frame to the client to request its identity,
followed by one or more requests for authentication information. It may
also send other EAP-request frames to the client during an active
connection as required for reauthentication.
E
XAMPLE
Console(config)#interface eth 1/2
Console(config-if)#dot1x timeout supp-timeout 300
Console(config-if)#
This command sets the time that an interface on the switch waits during an
authentication session before re-transmitting an EAP packet. Use the no
form to reset to the default value.
S
YNTAX
dot1x timeout tx-period seconds
no dot1x timeout tx-period
seconds - The number of seconds. (Range: 1-65535)
– 734 –