Configuring Local Snmpv3 Users; Figure 233: Showing Community Access Strings - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| Basic Administration Protocols

Simple Network Management Protocol

To show the community access strings:

Click Administration, SNMP.

Select Configure User from the Step list.

Select Show Community from the Action list.

Use the Administration > SNMP (Configure User - Add SNMPv3 Local User)

page to authorize management access for SNMPv3 clients, or to identify

the source of SNMPv3 trap messages sent from the local switch. Each

SNMPv3 user is defined by a unique name. Users must be configured with a

specific security level and assigned to a group. The SNMPv3 group restricts

users to a specific read, write, and notify view.

"snmp-server user" on page 667

These parameters are displayed:

User Name – The name of user connecting to the SNMP agent.

(Range: 1-32 characters)

Group Name – The name of the SNMP group to which the user is

assigned. (Range: 1-32 characters)

Security Model – The user security model; SNMP v1, v2c or v3.

Security Level – The following security levels are only used for the

groups assigned to the SNMP security model:

noAuthNoPriv – There is no authentication or encryption used in

SNMP communications. (This is the default security level.)

AuthNoPriv – SNMP communications use authentication, but the

data is not encrypted.

Troubleshooting