Network-Access Dynamic-Qos; Table 85: Dynamic Qos Profiles - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

Use this command to enable the dynamic QoS feature for an authenticated

network-access

port. Use the no form to restore the default.

Interface Configuration

switch configuration file.

[no] network-access dynamic-qos

The RADIUS server may optionally return dynamic QoS assignments to

be applied to a switch port for an authenticated user. The "Filter-ID"

attribute (attribute 11) can be configured on the RADIUS server to pass

the following QoS information:

Attribute Syntax

service-policy-in=policy-map-name service-policy-in=p1

rate-limit-input=rate

switchport-priority-default=value

ip-access-group-in=ip-acl-name

ipv6-access-group-in=ipv6-acl-

mac-access-group-in=mac-acl-

When the last user logs off of a port with a dynamic QoS assignment,

the switch restores the original QoS configuration for the port.

When a user attempts to log into the network with a returned dynamic

QoS profile that is different from users already logged on to the same

port, the user is denied access.

While a port has an assigned dynamic QoS profile, any manual QoS

configuration changes only take effect after all users have logged off of

Any configuration changes for dynamic QoS are not saved to the

| General Security Measures

Network Access (MAC Address Authentication)

rate-limit-input=100 (Kbps)

switchport-priority-default=2

ip-access-group-in=ipv4acl

ipv6-access-group-in=ipv6acl

mac-access-group-in=macAcl

Troubleshooting