Logging Sendmail; Logging Sendmail Host - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| System Management Commands

logging sendmail

This command enables SMTP event handling. Use the no form to disable

this function.

[no] logging sendmail

Global Configuration

Console(config)#logging sendmail

Console(config)#

This command specifies SMTP servers that will be sent alert messages. Use

the no form to remove an SMTP server.

[no] logging sendmail host ip-address

ip-address - IPv4 or IPv6 address of an SMTP server that will be

sent alert messages for event handling.

Global Configuration

You can specify up to three SMTP servers for event handing. However,

you must enter a separate command to specify each server.

To send email alerts, the switch first opens a connection, sends all the

email alerts waiting in the queue one by one, and finally closes the

To open a connection, the switch first selects the server that

successfully sent mail during the last connection, or the first server

configured by this command. If it fails to send mail, the switch selects

the next server in the list and tries to send mail again. If it still fails, the

system will repeat the process at a periodic interval. (A trap will be

triggered if the switch cannot successfully open a connection.)