Table 34: Oam Operation State - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

| Basic Administration Protocols

OAM Configuration

To perform a loopback test, first enable Remote Loop Back Mode, click

Test, and then click End. The number of packets transmitted and

received will be displayed.

These parameters are displayed:

Loopback Mode of Remote Device

Port – Port identifier. (Range: 1-12)

Loopback Mode – Shows if loopback mode is enabled on the peer. This

attribute must be enabled before starting the loopback test.

Loopback Status – Shows if loopback testing is currently running.

Loopback Test Parameters

Packet Number – Number of packets to send. (Range: 1-99999999;

Default: 10000)

Packet Size – Size of packets to send. (Range: 64-1518 bytes;

Default: 64 bytes)

Test – Starts the loop back test.

End – Stops the loop back test.

Loop Back Status of Remote Device

Result – Shows the loop back status on the peer. The loop back states

shown in this field are described below.

Table 34: OAM Operation State

Initiating Loopback

Remote Loopback

Terminating Loopback

Local Loopback

Packets Transmitted – The number of loop back frames

transmitted during the last loopback test on this interface.

Operating in normal mode with no loopback in progress.

The local OAM entity is starting the loopback process with its

peer. It has yet to receive any acknowledgement that the

remote OAM entity has received its loopback command request.

The local OAM client knows that the remote OAM entity is in

loopback mode.

The local OAM client is in the process of terminating the remote

The remote OAM client has put the local OAM entity in loopback

This status may be returned if the OAM loopback is in a

transition state but should not persist.