Show Interfaces Transceiver - Edge-Core ECS4810-12M Layer 2 Management Manual

| Interface Commands
C 28
HAPTER
show interfaces
transceiver
Table 97: show interfaces switchport - display description (Continued)
Field Description
Unknown-unicast Shows if unknown unicast storm suppression is enabled or disabled; if
Threshold enabled it also shows the threshold level
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 848).
Ingress/Egress Shows if rate limiting is enabled, and the current rate limit
Rate Limit
VLAN Membership Indicates membership mode as Trunk or Hybrid
Mode
Ingress Rule Shows if ingress filtering is enabled or disabled
Acceptable Frame Shows if acceptable VLAN frames include all types or tagged frames only
Type (page 940).
Native VLAN Indicates the default Port VLAN ID
Priority for Indicates the default priority for untagged frames
Untagged Traffic
GVRP Status Shows if GARP VLAN Registration Protocol is enabled or disabled
(page 934).
Allowed VLAN Shows the VLANs this interface has joined, where "(u)" indicates
untagged and "(t)" indicates tagged
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP
(page 934).
802.1Q-tunnel Shows if 802.1Q tunnel is enabled on this interface
Status
802.1Q-tunnel Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel
Mode Uplink (page
802.1Q-tunnel Shows the Tag Protocol Identifier used for learning and switching packets
TPID (page 950).
This command displays identifying information for the specified transceiver,
as well as the temperature, voltage, bias current, transmit power, and
receive power.
S
YNTAX
show interfaces transceiver [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: SFP ports 1-12)
D S
EFAULT ETTING
Shows all SFP interfaces.
C M
OMMAND ODE
Privileged Exec
– 840 –
(page
(page 943).
(page
948).
826).
(page 867).
(page 942).
(page 942).
(page 976).
941).
(page 947).