Mac-Vlan; Show Mac-Vlan - Edge-Core ECS4810-12M Layer 2 Management Manual

This command configures MAC address-to-VLAN mapping. Use the no form

mac-vlan

to remove an assignment.
S
YNTAX
mac-vlan mac-address mac-address vlan vlan-id [priority priority]
no mac-vlan mac-address {mac-address | all}
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
◆ The MAC-to-VLAN mapping applies to all ports on the switch.
Source MAC addresses can be mapped to only one VLAN ID.
◆
Configured MAC addresses cannot be broadcast or multicast addresses.
◆
When MAC-based, IP subnet-based, and protocol-based VLANs are
◆
supported concurrently, priority is applied in this sequence, and then
port-based VLANs last.
E
XAMPLE
The following example assigns traffic from source MAC address 00-00-00-
11-22-33 to VLAN 10.
Console(config)#mac-vlan mac-address 00-00-00-11-22-33 vlan 10
Console(config)#
This command displays MAC address-to-VLAN assignments.

show mac-vlan

C
OMMAND
Privileged Exec
C
OMMAND
Use this command to display MAC address-to-VLAN mappings.
mac-address – The source MAC address to be matched. Configured
MAC addresses can only be unicast addresses. The MAC address
must be specified in the format xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx.
vlan-id – VLAN to which the matching source MAC address traffic is
forwarded. (Range: 1-4093)
priority – The priority assigned to untagged ingress traffic.
(Range: 0-7, where 7 is the highest priority)
S
ETTING
M
ODE
U
SAGE
M
ODE
U
SAGE
– 965 –
| VLAN Commands
C 36
HAPTER
Configuring MAC Based VLANs