Displaying Connection Status - Edge-Core ECS4510-28P User Manual

D
ISPLAYING
C S
ONNECTION TATUS
Figure 30: Configuring Connections by Port Range
Use the Interface > Port > General (Show Information) page to display the
current connection status, including link state, speed/duplex mode, flow
control, and auto-negotiation.
CLI R
EFERENCES
"show interfaces status" on page 983
◆
P
ARAMETERS
These parameters are displayed:
◆ Port – Port identifier.
Type – Indicates the port type. (1000BASE-T, 1000BASE SFP
◆
10GBASE SFP+)
◆ Name – Interface label.
Admin – Shows if the port is enabled or disabled.
◆
Oper Status – Indicates if the link is Up or Down.
◆
Media Type – Only applies to ports 23-24 on ECS4510-28F.
◆
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
◆
Oper Speed Duplex – Shows the current speed and duplex mode.
◆
Oper Flow Control – Shows the flow control type used.
◆
3. ECS4510-28F
– 155 –
| Interface Configuration
C 5
HAPTER
Port Configuration
,
3