Figure 49: Showing Members Of A Dynamic Trunk - Edge-Core ECS4810-12M Layer 2 Management Manual

| Interface Configuration
C 5
HAPTER
Trunk Configuration
To show the active members of a dynamic trunk:
Click Interface, Trunk, Dynamic.
1.
Select Configure Trunk from the Step List.
2.
Select Show Member from the Action List.
3.
Select a Trunk.
4.

Figure 49: Showing Members of a Dynamic Trunk

To configure connection parameters for a dynamic trunk:
Click Interface, Trunk, Dynamic.
1.
Select Configure Trunk from the Step List.
2.
Select Configure from the Action List.
3.
Modify the required interface settings. (See
4.
on page 132 for a description of the interface settings.)
Click Apply.
5.
Figure 50: Configuring Connection Settings for Dynamic Trunks
To display connection parameters for a dynamic trunk:
Click Interface, Trunk, Dynamic.
1.
Select Configure Trunk from the Step List.
2.
– 160 –
"Configuring by Port List"