Show Interfaces Subnet-Vlan - Edge-Core ECS4810-12M Layer 2 Management Manual

◆
◆
◆
E
XAMPLE
The following example assigns traffic for the subnet 192.168.12.192, mask
255.255.255.224, to VLAN 4.
Console(config)#subnet-vlan subnet 192.168.12.192 255.255.255.224 vlan 4
Console(config)#
This command displays a brief summary of IP Subnet VLAN settings.
show interfaces
subnet-vlan
S
YNTAX
C
OMMAND
Privileged Exec
E
XAMPLE
The following example displays a summary of configured IP subnet-based
VLANs.
Console#show interfaces subnet-vlan
Port
--------
Eth 1/1
Eth 1/2
Eth 1/3
Eth 1/4
Eth 1/5
Eth 1/6
Eth 1/7
Eth 1/8
When an untagged frame is received by a port, the source IP address is
checked against the IP subnet-to-VLAN mapping table, and if an entry
is found, the corresponding VLAN ID is assigned to the frame. If no
mapping is found, the PVID of the receiving port is assigned to the
frame.
The IP subnet cannot be a broadcast or multicast IP address.
When MAC-based, IP subnet-based, and protocol-based VLANs are
supported concurrently, priority is applied in this sequence, and then
port-based VLANs last.
show interfaces subnet-vlan [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
M
ODE
IP Address
---------------
192.168.12.0
192.168.12.128
192.168.12.192
192.168.12.224
192.168.12.240
192.168.12.248
192.168.12.252
192.168.12.254
– 963 –
C
HAPTER
Configuring IP Subnet VLANs
Mask
---------------
255.255.255.128
255.255.255.192
255.255.255.224
255.255.255.240
255.255.255.248
255.255.255.252
255.255.255.254
255.255.255.255
| VLAN Commands
36