Cluster Commander; Cluster Ip-Pool - Edge-Core ECS4810-12M Layer 2 Management Manual

cluster commander

cluster ip-pool

E
XAMPLE
Console(config)#cluster
Console(config)#
This command enables the switch as a cluster Commander. Use the no
form to disable the switch as cluster Commander.
S
YNTAX
[no] cluster commander
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
Once a switch has been configured to be a cluster Commander, it
◆
automatically discovers other cluster-enabled switches in the network.
These "Candidate" switches only become cluster Members when
manually selected by the administrator through the management
station.
Cluster Member switches can be managed through a Telnet connection
◆
to the Commander. From the Commander CLI prompt, use the
rcommand id command to connect to the Member switch.
E
XAMPLE
Console(config)#cluster commander
Console(config)#
This command sets the cluster IP address pool. Use the no form to reset to
the default address.
S
YNTAX
cluster ip-pool ip-address
no cluster ip-pool
ip-address - The base IP address for IP addresses assigned to
cluster Members. The IP address must start 10.x.x.x.
D S
EFAULT ETTING
10.254.254.1
C M
OMMAND ODE
Global Configuration
– 653 –
| System Management Commands
C 21
HAPTER
Switch Clustering