Setting The Sntp Polling Interval; Figure 13: Setting The Polling Interval For Sntp - Edge-Core ECS4810-12M Layer 2 Management Manual

Use the System > Time (Configure General - SNTP) page to set the polling
S SNTP
ETTING THE
interval at which the switch will query the specified time servers.
P I
OLLING NTERVAL
CLI R
◆
P
The following parameters are displayed:
◆
◆
W
To set the polling interval for SNTP:
1.
2.
3.
4.
5.

Figure 13: Setting the Polling Interval for SNTP

EFERENCES
"Time" on page 643
ARAMETERS
Current Time – Shows the current time set on the switch.
SNTP Polling Interval – Sets the interval between sending requests
for a time update from a time server. (Range: 16-16384 seconds;
Default: 16 seconds)
I
EB NTERFACE
Click System, then Time.
Select Configure General from the Step list.
Select SNTP from the Maintain Type list.
Modify the polling interval if required.
Click Apply
– 119 –
| Basic Management Tasks
C 4
HAPTER
Setting the System Clock