Interface - Edge-Core ECS4810-12M Layer 2 Management Manual

| Interface Commands
C 28
HAPTER

interface

Table 96: Interface Commands (Continued)
Command Function
show interfaces Displays the administrative and operational status of
switchport an interface
show interfaces Displays the temperature, voltage, bias current,
transceiver transmit power, and receive power
Cable Diagnostics
test cable-diagnostics Performs cable diagnostics on the specified port
show cable-diagnostics Shows the results of a cable diagnostics test
Power Savings
power-save Enables power savings mode on the specified port
show power-save Shows the configuration settings for power savings
* Enabling hardware-level storm control with this command on a port will disable
software-level automatic storm control on the same port if configured by the
traffic-control command (page
This command configures an interface type and enters interface
configuration mode. Use the no form with a trunk to remove an inactive
interface.
S
YNTAX
[no] interface interface
interface
craft - Management port on the front panel.
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
vlan vlan-id (Range: 1-4093)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The craft interface is provided as an out-of-band management connection
which is isolated from all other ports on the switch. This interface must first
be configured with an IPv4 or IPv6 address before a connection can be
made through Telnet, SSH, or HTTP.
– 818 –
873).
Mode
NE, PE
PE
PE
PE
IC
PE
auto-