Saving Power - Edge-Core ECS4810-12M Layer 2 Management Manual

Hide thumbs Also See for ECS4810-12M Layer 2:

Table of Contents

These parameters are displayed for the load balance mode:

Destination IP Address - Load balancing based on destination IP

Destination MAC Address - Load balancing based on destination MAC

Source and Destination IP Address - Load balancing based on

source and destination IP address.

Source and Destination MAC Address - Load balancing based on

source and destination MAC address.

Source IP Address - Load balancing based on source IP address.

Source MAC Address - Load balancing based on source MAC address.

To display the load-distribution method used by ports in aggregated links:

Click Interface, Trunk, Load Balance.

Select the required method from the Load Balance Mode list.

Click Apply.

Figure 55: Configuring Load Balancing

Use the Interface > Green Ethernet page to enable power savings mode on

the selected port.

"power-save" on page 843

"show power-save" on page 844

IEEE 802.3 defines the Ethernet standard and subsequent power

requirements based on cable connections operating at 100 meters.

Enabling power saving mode can reduce power used for cable lengths

of 60 meters or less, with more significant reduction for cables of 20

meters or less, and continue to ensure signal integrity.

| Interface Configuration

Saving Power