Displaying Connection Status - Edge-Core ECS3510-10PD Management Manual

D
ISPLAYING
C S
ONNECTION TATUS
Figure 30: Configuring Connections by Port Range
Use the Interface > Port > General (Show Information) page to display the
current connection status, including link state, speed/duplex mode, flow
control, and auto-negotiation.
CLI R
EFERENCES
◆ "show interfaces status" on page 993
P
ARAMETERS
These parameters are displayed:
Port – Port identifier.
◆
Type – Indicates the port type. (100BASE-FX, 100BASE-TX,
◆
1000BASE-T, 100BASE SFP, 1000BASE SFP)
Name – Interface label.
◆
◆ Admin – Shows if the port is enabled or disabled.
Oper Status – Indicates if the link is Up or Down.
◆
Media Type – Media type used for combination ports.
◆
Autonegotiation – Shows if auto-negotiation is enabled or disabled.
◆
◆ Oper Speed Duplex – Shows the current speed and duplex mode.
Oper Flow Control – Shows the flow control type used.
◆
W I
EB NTERFACE
To display port connection parameters:
Click Interface, Port, General.
1.
Select Show Information from the Action List.
2.
– 155 –
| Interface Configuration
C 5
HAPTER
Port Configuration