Service Work
4. Turn switches on or off as required. Individual functions can be deactivated with these five
switches (Fig. 113, item 1) depending on the configuration (e.g. 4 and 5 off).
Fig. 50
Push-button module connections on the seat module
1 Switches
5. Install the cover.
6. Attach the push-button module to the holder.
7. Insert the batteries.
8. Switch on the control unit.
9. Test the functionality of the push-button module.
6.17.3 Installing the push-button module
CAUTION
Health risks due to a pinched cable. Pinching the cable while operating seat functions can impair
signal transmission by the push-button module, resulting in uncontrolled wheelchair behaviour. Extreme
care is therefore required when installing the cable.
The push-button module is attached with a magnetic holder or hook-and-loop fastener.
Preparation:
U Turn the control unit off.
U Remove the batteries (see section 6.3).
Tools:
U Allen wrench, size 5
Steps:
1. Magnetic holder: Attach the holder for the push-button module to the armrest.
2. Magnetic holder: Attach the push-button module to the holder. The push-button module is
held in place by two magnets mounted on the back of the holder.
If a magnetic holder is not used, the hook-and-loop holder is freely positioned as required.
44 | Ottobock
1
Skippi Plus