Push-Button Module; Preparing The Push-Button Module (Affixing Icons) - Otto Bock Skippi Plus Service Manual

Service Work

6.17 Push-button module

CAUTION
Risk of accidents due to uncontrolled driving behaviour. The push-button module is an option when
using the enAble50 system. Improper adaptation of the push-button control unit to a power wheelchair
which has components not included in the Ottobock modular system or modifications made later on
by the user are not permissible.
The push-button module can only be used in combination with a seat module.
The on-site service technician determines which functions are controlled by the push-button module.
The corresponding configuration of the parameter file for the enAble50 control unit cannot be
completed independently. Therefore, the service technician must export the parameter file to
their PC with the help of a PC programming station (PCPS; see the enAble50 instructions for
use (647G490=D/GB)) and send it to Ottobock by email with a request for the desired configu-
ration. Ottobock will amend/change the configuration file accordingly.
The service technician will subsequently import the file returned by Ottobock back into the con-
trol unit.
The push-button module is delivered as a mounting kit.
6.17.1 Preparing the push-button module (affixing icons)
The service technician must affix the corresponding icons to the push-button module according
to the selected configuration.
Preparation:
U Turn the control unit off.
U Remove the batteries (see section 6.3).
Steps:
1. Select an icon from the configuration panel, remove it from the backing and affix it in the
recess provided on the front of the push-button module.
INFORMATION
Ensure that the icons are properly aligned when they are affixed in the recesses of the push-button
module.
2. Store unused icons with the other wheelchair documentation.
3. Activate the fuse.
4. Switch on the control unit.
5. Test the functionality of the push-button module.
42 | Ottobock Skippi Plus