Mpf Pick Roller Removal - Lexmark MX81 Series Service Manual

11
Remove the MPF feeder lift plate.
Installation warning: When replacing the MPF feeder lift plate, ensure that the MPF feeder lift plate cable and
solenoid cable are properly rerouted and that all cables are properly reconnected. Make sure that these cables
are not pinched between the MPF feeder lift plate and the frame before replacing the screws.

MPF pick roller removal

1
Remove the left cover. See
2
Remove the controller board access shield. See
3
Remove the media tray. See
4
Open the control panel door.
5
Remove the toner cartridge.
6
Remove the imaging unit.
7
Remove the media turn guide. See
"Left cover removal (MX71x)" on page
"Controller board access shield removal" on page
"Media tray removal" on page
"Media turn guide removal" on page
Repair information
331
301.
374.
325.
7463
388.