7558-xxx
Remove the two screws securing the bracket (D) to the finisher.
5.
Remove the bracket (D).
6.
Remove the two screws securing the bracket (D) to the stepper motor (entrance/paddle) (C).
7.
Remove the stepper motor (entrance/paddle) (C).
8.
9.
Remove the belt (entrance/paddle) (B).
Reinstallation notes:
The tension of the belt (entrance/paddle) (B) is automatically adjusted by the force of the spring attached to
•
the belt tensioner bracket (A).
Tighten the two screws in the order shown.
•
Stepper motor (exit) assembly and belt (exit) removal
Remove the rear upper cover. See
1.
Loosen the two screws securing the belt tensioner bracket (A) to the finisher, and move it down as shown.
2.
Remove the belt (exit) (B) from the stepper motor (exit) (C).
3.
Service Manual
4-414
Connector
"Rear upper cover removal" on page
D
C
4-377.
Previous
Next
Go Back