Feed Solenoid - Xerox Phaser 3010 Service Manual

Feed Solenoid

PL2.3.21
Phaser 3010/3040/WorkCentre 3045 Service
1. Remove the Main Tray (page 4-58).
2. Remove the Front Cover (page 4-60).
3. Remove the Inner Front Cover (page 4-62).
4. Remove the Left Cover (page 4-64).
5. Remove the Right Cover (page 4-57).
6. Remove the Scanner (page 4-109).
7. Disconnect P/J7601 from the Front USB Board.
8. Disconnect P/J6501 from the WiFi Adaptor.
9. Remove the Top Cover (page 4-52).
10. Remove the Rear Cover (page 4-56).
11. Remove the IP Board (page 4-103).
12. Remove the Fax Board if present (page 4-105).
13. Remove the IP Board Bracket (page 4-106).
14. Disconnect P/J10 on the MCU Board.
15. Feed the solenoid harness through the opening near the Main Drive Assembly.
16. Release the solenoid and Registration Sensor harnesses from the feed solenoid
cover, then remove the cover.
17. Remove 1 screw (silver, tap, 8 mm), and remove the Feed Solenoid from the
printer.
Xerox Internal Use Only
Service Parts Disassembly
P/J10
s3040-081
4-85