Exit Jam - Xerox Phaser 3010 Service Manual

Exit Jam

Phaser 3010/3040/WorkCentre 3045 Service
Paper remaining at the Exit section of the Printer was detected.
Warning
Allow the Fuser to cool before servicing the printer.
Applicable Error
• 077-900: Exit Jam
Initial Actions
• Check the media path for obstructions or debris.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL5.1.1
■
MCU Board, PL7.1.3
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Check P/J18 on the MCU Board.
Is P/J18 connected securely.
2 Replace the Fuser (page 4-38).
Does the error persist?
Xerox Internal Use Only
Error Troubleshooting
Wiring and Plug/Jack Map References
"Map 2" on page 7-4
■
"Fuser" on page 7-18
■
Yes
Go to Step 2.
Replace the
MCU Board
(page 4-43).
No
Secure P/J18.
Complete.
2-103