Exit On Jam - Xerox Phaser 3010 Service Manual

Error Troubleshooting

Exit On Jam

Applicable Error
Initial Actions
2-100
The paper does not reach the Exit Sensor within the specified time.
• 077-106: Exit On Jam
• Check the media path for obstructions or debris.
• Cycle printer power.
• If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Registration Sensor, PL2.3.10
■
Main Drive Motor, PL6.1.1
■
MCU Board, PL7.1.3
■
Troubleshooting Procedure Table
Step Actions and Questions
1 Test the Registration Sensor.
Does the Registration Sensor
function correctly?
2
Test the Main Drive Motor.
Does the motor function correctly?
3 Replace the MCU Board (page 4-43).
Does the error persist?
Xerox Internal Use Only
Wiring and Plug/Jack Map References
"Map 2" on page 7-4
■
"Drive" on page 7-14
■
Yes
Go to Step 2.
Go to Step 3.
Contact your
designated
field support for
assistance.
Phaser 3010/3040/WorkCentre 3045 Service
No
Replace the
Registration
Sensor
(page 4-30).
Replace the
Main Drive
Motor
(page 4-41)..
Complete.