Test Print; Parameter - Xerox Phaser 3010 Service Manual

Test Print

Parameter

Item
Registration
Machine
Toner
Phaser 3010/3040/WorkCentre 3045 Service
Print Counter
Clear All NVM
Clear Job Log
Apply New Settings
Restart printer to apply new
settings
Two test prints are available, Test pattern ASIC and LPH K. Select the pattern from
the menu and click the print button.
This function reads/writes the parameters in the table. Click Apply new settings or
Restart printer to apply new settings button after the setting is completed to
change the value in NVM.
Range Parameter
-94 ~ 94 Regi Lead Offset
-68 ~ 68 Regi Side Offset
- Total PV
- FC PV
- DEVE Round time K
- XERO Round time
- K Dispense Time
- K Pixel
- Sheets of Custom Mode Start
- Sheets of Custom Mode End
- K Toner PV
- K Toner Pixel
- Life K Toner Dispense Time
- Life K Toner Waste toner count
Xerox Internal Use Only
Displays the respective counter values in the
master NVM and backup NVM. (read only)
Initializes the NVM of the Image Processor
Board.
Initializes the print job history.
This button should be clicked to move to any
other setting menu from the current menu in
operation.
NOTE After completion of all operations the Restart
printer to apply new settings button should be
clicked without exceptions.
Click this button when ready to apply your
changes to the settings.
The restart of a printer is required in order to
confirm this setup.
Function
Value of Lead Offset
Value of Side Offset
Counter of Total PV
Counter of FC PV
Counter of DEVE Round time
Counter of XERO Round time
Counter of Dispense Time
Counter of K Pixel
Counter of Sheets of Custom Mode Start
Counter of Sheets of Custom Mode End
Counter of Total PV
Counter of Toner Pixel
Counter of Toner Dispense Time
Counter of Toner Waste toner count
Reference
A-7