Image Quality
Unfused Image
Initial Actions
3-28
The image is not completely fused to the paper. The image easily rubs off.
Warning
Allow the Fuser to cool before servicing the printer.
•
Check the media path.
•
Check the Fuser connection.
Troubleshooting Reference Table
Applicable Parts
Fuser, PL5.1.1
■
MCU Board, PL7.1.3
■
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check the media being used.
Is the media dry and
recommended?
2
Does the image print correctly?
3
Check the Toner type.
Is non-Xerox Toner in use?
4
Does the image print correctly?
5
Replace the Fuser (page 4-38).
Does the error persist?
6
Replace the MCU Board (page 4-43).
Does the error persist?
Xerox Internal Use Only
Example Print
Yes
Go to Step 3.
Complete.
Replace toner,
then go to
Step 4.
Complete.
Go to Step 6.
Contact field
support for
assistance.
Phaser 3010/3040/WorkCentre 3045 Service
4510 051
No
Replace with
dry, approved
media, then go
to Step 2.
Go to Step 3.
Go to Step 5.
Go to Step 5.
Complete.
Complete.