Error Troubleshooting
WorkCentre 3045 Sensor Test Procedures
2-40
The following Digital Input procedures test each print engine sensor using Service
Diagnostics. When a paper jam occurs, or an error message or code is displayed,
execute these tests to isolate the problem.
•
Exit Sensor
•
Registration Sensor
•
Rear Door Interlock Switch
•
K CRUM
Interlock Switch
Registration Sensor
Note
Pressing the Cancel button stops the sensor tests. Press the Back button to go
back to the Engine Diag menu.
During sensor tests, other diagnostic functions can not be performed
simultaneously. The printer only accepts operations for the DI components and
exit of the sensor tests.
Parameters for the Digital Input tests are as shown in the following table.
Code
DI-3
DI-4
DI-5
DI-7
Xerox Internal Use Only
Component
K CRUM
Exit Sensor
Registration Sensor
Rear Door Interlock Switch
Phaser 3010/3040/WorkCentre 3045 Service
Exit Sensor
CRUM
s3040-155