Paper Size Mismatch
Phaser 3010/3040/WorkCentre 3045 Service
The size of paper in the Main Paper Tray, or Bypass Tray, does not match the
specified print size.
Applicable Error
•
024-958: Paper Size Match
Initial Actions
•
Check that the correct paper is in the paper tray. Change the paper if
necessary.
•
Cycle printer power.
•
If the problem persists, use the following procedure.
Troubleshooting Reference Table
Applicable Parts
Registration Sensor, PL2.3.10
■
Regi Sensor Harness, PL2.3.22
■
MCU Board, PL7.1.3
■
Troubleshooting Procedure Table
Step
Actions and Questions
1
Check connectors P/J23 and P/J230
between the MCU Board and the
Registration Sensor.
Are the connections secure?
2
Does the error persist?
3
Disconnect P/J23 and P/J230. Check
harness continuity.
Is the harness damaged?
4
Disconnect the MCU Board P/J23.
Is the voltage across ground and
J23-1 +3.3 VDC?
Xerox Internal Use Only
Error Troubleshooting
Wiring and Plug/Jack Map References
"Map 1" on page 7-3
■
"Drive" on page 7-14
■
Yes
Go to Step 2.
Go to Step 3.
Repair the
harness.
Replace the
Registration
Sensor
(page 4-30).
No
Secure the
connectors.
Complete.
Go to Step 4.
Replace the
MCU Board
(page 4-43).
2-75