Moving The Printer - Xerox Phaser 3010 Service Manual

Maintenance

Moving the Printer

6-4
The printer, with toner installed, weighs 11.3 kg (24.9 lb.).
Caution
When moving the printer over long distances, remove the Toner Cartridge to
prevent toner spills.
Before moving the printer, do the following:
1. Turn the printer Off and disconnect all cables.
2. Allow the printer to cool about 40 minutes.
3. Remove media from the output tray and return the Tray Extension to its non-
extended position.
4. Remove the Bypass Tray, then push in the center paper guide until it stops.
5. Push in the side paper guides until they stop.
6. Place the Bypass Tray inside the printer, on the Main Tray.
7. Fold up the Main Tray Extension to cover the paper feed.
8. Lift and carry the printer as shown in the illustration.
Caution
Do not tilt the printer more than 10 degrees to the front or back, or left or
right. Tilting the printer more than 10 degrees may cause toner spillage.
Caution
Failure to properly repackage the printer for shipment can result in damage
not covered by the warranty, Service Agreement, or Total Satisfaction
Guarantee.
Xerox Internal Use Only
s3040-166
Phaser 3010/3040/WorkCentre 3045 Service