Fastener Types - Xerox Phaser 3010 Service Manual

Service Parts Disassembly

Fastener Types

4-4
The following table lists the types of screws used to assemble the printer. The
procedures provide dimensions for screws being removed.
Screw Types Used in this Product
Type Application
Self-tapping,
plastic
Parts etc.
Self-tapping,
hex-head,
plastic, with
flange
Self-tapping,
plastic, with
flange
Sheet Metal,
silver
Parts etc.
Sheet Metal,
silver with
lock washer
Parts etc.
Caution
Use care when installing self-tapping screws in plastic. To properly start the
screw in plastic, turn the screw counter-clockwise in the hole until you feel the
screw engage the threads, then tighten as usual. Improperly aligning or over
tightening the screw can result in damage to previously tapped threads.
Always use the correct type and size screw. Using the wrong screw can
damage tapped holes. Do not use excessive force to remove or install either a
screw or a printer part.
Xerox Internal Use Only
Shape
Coarse
Plastic
Sheet
Metal
Sheet
Metal
Phaser 3010/3040/WorkCentre 3045 Service
Characteristics
1. Silver colored.
2. Screw thread is coarse
compared to metal
screw.
3. Screw tip is thin.
1. Silver colored.
2. Screw thread is coarse
compared to metal
screw.
3. Screw tip is thin.
4. Used in Fuser
1. Silver colored.
2. Screw thread is coarse
compared to metal
screw.
3. Screw tip is thin.
4. Used in Fuser
1. Silver colored.
2. Diameter is uniform.
1. Silver colored.
2. Includes a toothed
washer.
3. Diameter is uniform.
4. Used for grounding
terminals.