Fuser - Xerox Phaser 3010 Service Manual

Service Parts Disassembly

Fuser

PL5.1.1
4-38
Warning
Allow the Fuser to cool before performing this procedure.
1. Remove the Main Tray (page 4-13).
2. Remove the Front Cover (page 4-15).
3. Remove the Left Cover (page 4-16).
4. Remove the Right Cover (page 4-12).
5. Remove the Top Cover (page 4-7).
6. Remove the Rear Cover (page 4-11).
7. Disconnect P/J201 on the LVPS, and release the harness from the guide.
8. Disconnect P/J18 from the MCU Board.
9. Remove 3 screws (hex-head, tap, 10mm) that secure the Fuser to the chassis.
P/J18
Xerox Internal Use Only
P/J201
Phaser 3010/3040/WorkCentre 3045 Service
s3040-103