Xerox Phaser 3010 Service Manual page 81

Phaser 3010/3040/WorkCentre 3045 Service
Test Control Panel
Scanner Test 2 ADF Motor -On
■
ADF Motor -Off
■
All Test
Start
■
Processing
■
Check OK or
■
<Failed Test> Error
IOT Diag
Tests for print engine components.
Sensor Test At the start,
L - 0 is displayed.
When a sensor is
turned On from Off, L
changes to H and
back to L while the
counter increments.
Component Tests
Test
Exit Sensor
Regi Sensor
Interlock Switch
K CRU
Motor Test These tests check operation of the electromechanical
components. Press OK to run the selected test. Press Stop to
exit the test. The display returns to the Service Mode menu.
NOTE During the Motor Tests, no other diagnostic functions can be performed.
The printer only accepts component and exit commands.
Component Tests
Test
Main Motor (FULL)
Main Motor (SLOW)
Feed Solenoid
Toner Motor
DBAC ON
DBDC ON
TR1+ ON
TR2+ ON
TR2- ON
CR ON
MOB LED ON
ADC LED ON
24V ON
HV CLK ON
NVM Settings Edits, saves, loads, and prints NVM information.
Xerox Internal Use Only
Error Troubleshooting
Test Description
This test checks the motor system for
the ADF document handling.
This test runs all ESS Diag tests except
OP Panel, USB Host test, Lamp test, and
the Scanner test. Test returns Check OK
or failed test name.
These tests check whether the sensors
operate normally. Press OK to run the
selected test. Press Stop to exit the test.
The display returns to the Service Mode
menu.
NOTE During the Sensor Test, no other
diagnostic functions can be performed.
The printer only accepts DI components
and exit commands.
Component
Exit Sensor
Registration Sensor
Interlock Switch
Toner Cartridge CRUM
Component
Main Drive Motor
Caution: When checking the Main
Motor, stop the test within 10
seconds. Executing this test
for 10 seconds or longer may
damage the printer.
Feed Solenoid
Toner Motor
Caution: When checking the toner
motors, stop the test within 3
seconds. Executing this test
for 3 seconds or longer may
cause damage to the printer.
NOTE The use of DBAC ON, DBDC ON, TR1+ ON,
TR2+ ON, TR2- ON, CR ON, MOB LED ON,
ADC LED ON, 24V ON, HV CLK ON is
prohibited to avoid shock hazards since
they are high-voltage outputs.
2-27