Dc Power Troubleshooting - Xerox Phaser 3010 Service Manual

Error Troubleshooting

DC Power Troubleshooting

Initial Actions
2-120
• Cycle printer power.
• If the problem persists, follow the procedure below.
Troubleshooting Procedure Table
Step Actions and Questions
1 When the printer is turned on, can
you hear the motor?
2
Is the Control Panel working?
3 Reseat both ends of the Control
Panel cable.
Does the error persist?
4
Reseat the connectors on the Image
Processor Board.
Does the error persist?
5 Reseat the connectors on the MCU
Board.
Does the error persist?
Xerox Internal Use Only
Yes
Go to step 2.
Go to step 4.
Go to step 4.
Complete.
Replace the
LVPS
(page 4-48).
Phaser 3010/3040/WorkCentre 3045 Service
No
Go to step 5.
Go to step 3.
Complete.
Replace the IP
Board
(page 4-45)
and Control
Panel
(page 4-116).
Complete.