Damaged Media - Xerox Phaser 3010 Service Manual

Image Quality

Damaged Media

Initial Actions
3-22
Paper comes out from the printer wrinkled, folded, or worn-out.
Warning
Allow the Fuser to cool before servicing the printer.
• Check the paper transfer path.
• Ensure there is no debris on the transfer path.
• If feeding through the manual feed slot, try feeding from Tray 1.
Troubleshooting Reference Table
Applicable Parts
Feed Roller, PL2.2.4
■
Left and Right Feed Roller Cam,
PL2.2.2 and PL2.2.7
Registration Roller, PL2.3.1
■
Registration Pinch Roller, PL2.3.2
■
Fuser, PL5.1.1
■
Separator Pad, PL2.2.11
■
MCU Board, PL7.1.3
■
Note
The Main Tray is recommended for media feeding because paper fed from the
Bypass Tray is prone to skew depending on how the sheet is fed.
Troubleshooting Procedure Table
Step Actions and Questions
1 Check the paper condition.
Is the paper dry and approved for
use?
2 Check the media path for
contamination or debris.
Is there contamination or debris in
the paper path?
3
Does the image print correctly?
Xerox Internal Use Only
Example Print
Yes
Go to Step 3.
Clean the
media path,
and then go to
Step 3.
Complete.
Phaser 3010/3040/WorkCentre 3045 Service
s3040-179
No
Replace with
dry, approved
paper, then go
to Step 2.
Go to Step 4.
Go to Step 4.