Fuser - Xerox Phaser 3010 Service Manual

Service Parts Disassembly

Fuser

PL5.1.1
4-92
Warning
Allow the Fuser to cool before servicing the printer.
1. Remove the Main Tray (page 4-58).
2. Remove the Front Cover (page 4-60).
3. Remove the Inner Front Cover (page 4-62).
4. Remove the Toner Cartridge (page 4-5).
5. Remove the Right Cover (page 4-57).
6. Remove the Left Cover (page 4-64).
7. Remove the Scanner (page 4-109).
8. Disconnect P/J7601 from the Front USB Board.
9. Disconnect P/J6501 from the WiFi Adaptor.
10. Remove the Top Cover (page 4-52).
11. Open the Rear Door.
12. Remove the Rear Cover (page 4-11).
13. Disconnect P/J201 on the LVPS, and release the harness from the guide.
14. Disconnect P/J18 from the MCU Board.
15. Remove 3 screws (hex-head, tap, 10mm) that secure the Fuser to the chassis.
Xerox Internal Use Only Phaser 3010/3040/WorkCentre 3045 Service