Changing A Serial Number - ADEMCO Vista-20 Installation Instructions Manual

Enter Zn Num.
(00 = Quit)
18
tine Numberentered
T
!&piCal summarydisplay
II
Zn ZT P RC In: L
18 03 1 3C RF:
II
Current I nput(Loop)Numb&
withtlashingcursor
Delete S/N ?
O= NO, l=
Yes
4. Enter the zone number to which the existing
transmitter has been assigned.
5. Press* to contixiue.
6. A
summary display wiIl appear showing
amming for the selectedzone.
current progr
Enter "O".This will deletethe existing "3".
Press *to continue.
7.
8.
Press "1" for Yes.
The serial number for the transmitter in zone
18 has now been deleted, and a prompt to
enter the next zone number
will
automaticallybe displayed.
If the transmitter is a multi-button type, the
previous steps 4-7 must be repeated for each
of the zones that have been assigned to each
button.
If no other transmitter serial numbers are to
be deleted, exit by keying "00" and pressing
the * key.
Changing a Serial Number
Use this
procedure if a transmitter in the system has to be replaced for any
reason.
Example A 5803 transmitter's
non-replaceablebattery has iinal.ly run down,
and you are going to replace the 5803 with a new unit (which must be
assignedto the samezone, of course).
1. Delete the serial number using the procedure describedpreviously in the
"Deleting a Serial Number" section.
2. Re-leam the serial number of the new transmitter using the procedure
describedpreviously in the "Adding a Serial Number" section.
-74-