Deleting A Transmitter Serial Number From A Zone In 56 Mode; Checkout Procedure For Wireless Zones - ADEMCO Vista-10SEa Installation And Setup Manual

2. Enter the zone number and press [ ]. A summary display will appear.
3. Press [ ] again.
2 0 Zo ne T yp e
Not Used
2 0 Delete Zo ne?
1 = Yes
Deleting a Transmitter Serial Number From a Zone in 56 Mode (5800 System)
You can use the abbreviated procedure below to delete a serial number from a zone, using
the 56 Mode.
1. In the programming mode, press [ ][5][6] to enter Zone Programming mode.
2. Enter the zone number and press [ ] repeatedly until the cursor is under the RF Input
Loop (L) position. This is the specific input (loop) or button on the transmitter that has
been entered for that zone.
3. Enter a [0] at this point, then press [ ].
4. A prompt "Delete S/N?" will appear.
Enter "Yes" to delete the existing serial number from the system.
Note that the other programmed values for that zone will not be deleted. This will allow
you to reinstate a new transmitter in its place.
5. A display for the next zone number will appear. To exit, enter "00."
6. Press 99 to exit the programming mode.

Checkout Procedure for Wireless Zones

Transmitter ID Sniffer Mode (5800 RF Systems)
When you have installed all transmitters, use the Transmitter Sniffer mode to test that they
have all been properly programmed.
1. Enter Installer Code + # + 3. The keypad will display all zone numbers of wireless
units programmed into the system.
2. Fault each wireless zone, causing each device to transmit. As the system receives a
signal from each of the transmitters, the zone number of that transmitter will disappear
from the display.
3. To exit the Transmitter Sniffer mode, enter the Installer Code + (OFF).
If a 5800 Transmitter is not enrolled, its zone number will not turn off.
Go/No Go Test (5800 RF Systems)
Before mounting transmitters permanently, conduct Go/No Go tests to verify adequate signal
4. The "Zone Type" prompt will appear. Enter [0][0]. This
sets the zone type to "Not Used."
00
Press [ ] to continue.
5. The next prompt will ask whether you want to delete the
zone.
0 = No
"Yes" will permanently remove the zone from the system,
while a "No" will disable it but retain all data except the
original zone type. You can return to this zone later and
put back an active zone type to re-enable it.
A serial number that has been entered for a 5800 sys-
tem will not be deleted if you temporarily disable
the zone by answering "No" to the prompt above.
If only the physical transmitter is to be removed or
changed (i.e., its serial number deleted, as when replacing
a unit that has a nonremovable battery), it can be done in
56 Mode, as indicated next.
Section 6: Wireless (RF) Zone Expansion
6-11