Mazda RX-8 Workshop Manual page 1821

< Previous Next >
2011 - RX-8 - Brakes
DSC CONFIGURATION
1. Connect the M-MDS to the DLC-2.
2. After the vehicle is identified, select the following items from the initialization screen of the M-
MDS.
When using the IDS (laptop PC)
When using the PDS (Pocket PC)
3. Then, select items from the screen menu in the following order.
1. Select "Programmable Module Installation".
2. Select "ABS".
4. Perform the configuration according to the directions on the screen.
5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
If a DTC (s) is detected, perform the applicable DTC inspection. (See
BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL
1. Select "Module Programming".
1. Select "Programming".
2. Select "Module Programming".
ON-
(DSC)].)