Mazda RX-8 Workshop Manual page 1823

< Previous Next >
2011 - RX-8 - Brakes
DSC HU/CM REMOVAL/INSTALLATION
CAUTION:
When replacing the DSC HU/CM, the configuration procedure must be done before removing the DSC HU/CM. If the
configuration is not completed before removing the DSC HU/CM, DSC will not work properly after installation of the
DSC HU/CM.
The DSC may not function normally when the DSC HU/CM is replaced. After installation, always perform the
initialization procedures for the combined sensor and the steering angle sensor.
The internal parts of the DSC HU/CM could be damaged if dropped. Be careful not to drop the DSC HU/CM. Replace
the DSC HU/CM if it is subjected to an impact.
1. Remove the engine cover. (See
2. Remove the front suspension tower bar. (See
FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Configurate the DSC HU/CM. (See
6. After installation, perform the combined sensor initialization procedure. (See
PROCEDURE.)
7. After installation, perform the steering angle sensor initialization procedure. (See
INITIALIZATION PROCEDURE.)
ENGINE COVER REMOVAL/INSTALLATION
FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION
DSC CONFIGURATION.)
[13B-MSP].)
[AT].)
COMBINED SENSOR INITIALIZATION
STEERING ANGLE SENSOR
[MT].) (See