Configuring Client Settings - Motorola Solutions WiNG 5.2.6 Reference Manual

6 - 32 WiNG 5.2.6 Access Point System Reference Guide
Blacklist Duration
15.Set a Firewall Session Hold Time
user credentials and Firewall state information when a client roams. The default setting is 30 seconds.
16.Select OK
last saved configuration.
WLAN Firewall Deployment Considerations
Before defining an access control configuration on a WLAN, refer to the following deployment guidelines to ensure
the configuration is optimally effective:
• IP and non-IP traffic on the same Layer 2 interface can be filtered by applying both an IP ACL and a MAC ACL to
the interface.

6.1.4 Configuring Client Settings


Wireless LANs
Each WLAN can maintain its own client setting configuration. These settings include wireless client inactivity
timeouts and broadcast configurations. An AP-6532, AP-7131, AP-7161 or AP-8132 model access point can support
up to 256 clients per access point. An AP-6511 or AP-6521 model can support up to 128 clients per access point. Thus,
client load balancing can be enforced for the WLAN as more and more WLANs are deployed.
1. Select Configuration
available to the wireless network.
2. Select the
an existing WLAN.
3. Select the
Select the checkbox and define a setting between 0 - 86,400 seconds.
Once the blacklist duration has been exceeded, offending clients can
reauthenticate.
in either Seconds (1 - 300) or Minutes (1 - 5). This is the hold time for caching
when completed to update this WLAN's Firewall settings. Select
> Wireless > Wireless LANs
Add button to create a new WLAN, or select and existing WLAN and
Client Settings tab.
Reset to revert the screen back to its
to display a high-level display of the existing WLANs
Edit to modify the properties of