Motorola Solutions WiNG 5.2.6 Reference Manual page 155

5. Either select an access point from those displayed and select Edit, or use the Device Browser in the lower left-hand
side of the UI to select an access point.
6. Select the Set as Virtual Controller AP
Standalone to Virtual Controller AP. Remember that only one Virtual Controller can manage (up to) 24 access points of
the same model. Thus, an administrator should take care to change the designation of a Virtual Controller AP to
Standalone AP to compensate for a new Virtual Controller AP designation.
7. Select the Adopt Unknown APs Automatically
recognize. While this option may help in the administration and management of all the APs in the network, in does
introduce the risk of allowing device association to a potential rogue device. That's why this setting is disabled by
default.
8. Select OK to save the changes. Select
needed.
Figure 5-52 Virtual Controller AP Designation screen
radio button to change the selected access point's designation from
option to allow the Virtual Control to adopt APs it does not
Reset to revert to the last saved configuration.
Device Configuration 5 - 97
Delete obsolete rows as