Radios - Motorola Solutions WiNG 5.2.6 Reference Manual

12 - 54 WiNG 5.2.6 Access Point System Reference Guide
4. The Access Point
IP Address
VLAN
Ping Mode
State
Refresh

12.3.9 Radios


Access Point Statistics
The Radio statistics screens display information on access point radios. The actual number of radios depend on the
access point model and type. This screen displays information on a per radio basis. Use this information to refine and
optimize the performance of each radio and therefore improve network performance.
Figure 12-32 Access Point - Critical Resources screen
Critical Resource screen displays the following:
Lists the IP address of the critical resource. This is the address the device
assigned and is used by the access point to ensure the critical resource is
available.
Lists the access point VLAN on which the critical resource is available.
Describes the ping mode as either:
arp-only – Uses the Address Resolution Protocol (ARP) for only pinging the
critical resource. ARP is used to resolve hardware addresses when only the
network layer address is known.
arp-icmp – Uses both ARP and Internet Control Message Protocol (ICMP) for
pining the critical resource and sending control messages (device not
reachable, requested service not available, etc.).
Defines the operational state of each listed critical resource.
Select the Refresh button to update the screen's statistics counters to their
latest values.