Motorola Solutions WiNG 5.2.6 Reference Manual page 66

5 - 8 WiNG 5.2.6 Access Point System Reference Guide
2. Select Devices.
3. Select System Profile
General configuration options display by default, with the profile activated for use with this access point model.
4. Select + Add Row
resources the used it obtain system time by the access point's profile. Set the following parameters to define the
NTP configuration:
AutoKey
Key
Prefer
Server IP
Version
5. Select OK
configuration.
from the options on left-hand side of the UI.
Figure 5-3 General Profile screen
below the Network Time Protocol (NTP) table to define the configurations of NTP server
Select the radio button to enable an autokey configuration for the NTP
resource. The default setting is disabled.
If an autokey is not being used, manually enter a 64 character maximum key
the access point and NTP resource share to securely interoperate.
Select the radio button designate this particular NTP resource as preferred. If
designating multiple NTP resources, preferred resources will be given first
opportunity to connect and provide NTP calibration.
Set the IP address of each server added as a potential NTP resource.
Use the spinner control to specify the version number used by this NTP server
resource. The default setting is 0.
to save the changes made to the general profile configuration. Select Reset to revert to the last saved