Motorola Solutions WiNG 5.2.6 Reference Manual page 200

5 - 142 WiNG 5.2.6 Access Point System Reference Guide
Use DHCP to obtain
Gateway/DNS
Servers
Secondary Addresses
12. Define or override the
Select either the Inside, Outside or None radio buttons.
• Inside - The inside network is transmitting data over the network its intended destination. On the way out, the
source IP address is changed in the header and replaced by the (public) IP address.
• Outside - Packets passing through the NAT on the way back to the LAN are searched against to the records
kept by the NAT engine. There the destination IP address is changed back to the specific private class IP
address in order to reach the LAN over the switch managed network.
• None - No NAT activity takes place. This is the default setting.
13. Select OK
the last saved configuration.
14. Select the
Select this option to allow DHCP to obtain a default gateway address, and DNS
resource for one virtual interface. This setting is disabled by default and only
available when the Use DHCP to Obtain IP option is selected. AP-6532,
AP-7131, AP-7161 and AP-8132 models have on onboard DHCP server
resources, while AP-6511 and AP-6521 models do not.
Use the Secondary Addresses parameter to define additional IP addresses to
associate with VLAN IDs. The address provided in this field is used if the
primary IP address is unreachable.
Network Address Translation (NAT)
NOTE: Refer to Setting the Profile's NAT Configuration on page 5-64
creating a profile's NAT configuration.
button to save the changes and overrides to the Basic Configuration screen. Select
Security tab.
direction.
for instructions on
Reset to revert to