Motorola Solutions WiNG 5.2.6 Reference Manual page 157

Figure 5-53 Device Overrides - Basic Configuration screen
5. Set the following Configuration
System Name
Area
Floor
6. Refer to the Device Overrides
deviates it's configuration from the configuration shared by the access point profile.
7. Refer to the Set Clock parameter to update the system time.
Refer to the Device Time
Select Refresh as required to update the device's system time.
settings for the target device:
Provide the selected device a system name up to 64 characters in length. This
is the device name that appears within the RF Domain or Profile the access
points supports and is identified by
Assign the access point an Area representative of the location the access point
is physically deployed. The name cannot exceed 64 characters. Assigning an
area is helpful when grouping access points in Profiles, as access points in the
same physical deployment location may need to share specific configuration
parameters in respect to radio transmission and interference requirements
specific to that location.
Assign the target a access point a building Floor name representative of the
location the access point was physically deployed. The name cannot exceed 64
characters. Assigning a building Floor name is helpful when grouping devices
in Profiles, as devices on the same physical building floor may need to share
specific configuration parameters in respect to radio transmission and
interference requirements specific to that location.
field to assess whether an access point configuration update has been made the
parameter to assess the device's current time, or whether the device time is unavailable.
Device Configuration 5 - 99