Motorola Solutions WiNG 5.2.6 Reference Manual page 230

5 - 172 WiNG 5.2.6 Access Point System Reference Guide
10. Set or override the following
Bridging Mode
IP Outbound Tunnel
ACL
MAC Outbound Tunnel
ACL
11. Set or override the following
Trust ARP Responses
Trust DHCP Responses
Edge VLAN Mode
12. Select the
saved configuration.
Extended VLAN Tunnel
Specify one of the following bridging mode for use on the VLAN.
Automatic: Select Automatic mode to let the controller determine the best
bridging mode for the VLAN.
Local: Select Local to use local bridging mode for bridging traffic on the
VLAN.
Tunnel: Select Tunnel to use a shared tunnel for bridging traffic on the VLAN.
Tunnel must be selected to successfully create a mesh connection between
two Standalone APs.
isolated-tunnel: Select isolated-tunnel to use a dedicated tunnel for bridging
traffic on the VLAN.
Select an IP Outbound Tunnel ACL for outbound traffic from the drop-down
menu. If an appropriate outbound IP ACL is not available click the create
button to make a new one.
Select a MAC Outbound Tunnel ACL for outbound traffic from the drop-down
menu. If an appropriate outbound MAC ACL is not available click the create
button to make a new one.
NOTE: If creating a mesh connection between two access points in Standalone AP
mode, Tunnel must be selected as the Bridging Mode to successfully create the mesh link
between the two access points.
Layer 2 Firewall
Select the radio button to use trusted ARP packets to update the DHCP Snoop
Table to prevent IP spoof and arp-cache poisoning attacks. This feature is
disabled by default.
Select the radio button to use DHCP packets from a DHCP server as trusted
and permissible within the network. DHCP packets are used to update the
DHCP Snoop Table to prevent IP spoof attacks. This feature is disabled by
default.
Select the radio button to enable edge VLAN mode. When selected, the IP
address in the VLAN is not used for normal operations, as its now designated
to isolate devices and prevent connectivity. This feature is enabled by
default.
OK button to save the changes and overrides to the General tab. Select
parameters:
parameters:
Reset to revert to the last