Motorola Solutions WiNG 5.2.6 Reference Manual page 381

2. Select the Activate Firewall IPS Policy
parameters for configuration. Ensure this option stays selected to apply the configuration to the access point profile.
3. Within the Wireless IPS Status
setting is enabled.
4. Enter an Interval to Throttle Packets
(1 - 24) or Days (1). This interval represents the duration event duplicates are not stored in history. The default setting
is 120 seconds.
5. Refer to the Rogue AP Detection
Enable Rogue AP
Detection
Wait Time to
Determine AP
Status
Ageout for AP
Entries
Figure 7-8 Wireless IPS screen - Settings tab
option on the upper left-hand side of the screen to enable the screen's
field, select either Enabled or Disabled to activate or de-activate WIPS. The default
in either Seconds (1 - 86,400), Minutes (1 - 1,400), Hours
field to define the following detection settings for this WIPS policy:
Select the checkbox to enable the detection of unsanctioned APs from this
WIPS policy. The default setting is disabled.
Define a wait time in either Seconds (10 - 600) or Minutes (0 - 10) before a
detected AP is interpreted as a rogue (unsanctioned) device, and
potentially removed. The default interval is 1 minute.
Set the interval the WIPS policy uses to ageout rogue devices. Set the
policy in either Seconds (30 - 86,400), Minutes (0- 1,440), Hours (1 - 24) or
Days (1). The default setting is 5 minutes.
Security Configuration 7 - 21