Motorola Solutions WiNG 5.2.6 Reference Manual page 203

Type
Description
Admin Status
RF Mode
Channel
Transmit Power
7. If required, select a radio configuration and select the
Figure 5-78 Profile Overrides - Access Point Radio Settings tab
The Radio Settings tab displays by default.
Displays the type as either Radio (for typical client support) or sensor. If setting
an AP-6521 or AP-6511 model access point to function as a sensor, the access
point must be rebooted before it can begin to operate as a sensor, since those
models support a single radio.
Displays a brief description of the radio provided by the administrator when the
radio's configuration was added or modified.
Defines the radio as either enabled or disabled for client or sensor support.
Displays whether each listed radio is operating in the 802.11a/n or
802.11b/g/n radio band. If the radio is a dedicated sensor, it will be listed as a
sensor to define the radio as not providing typical WLAN support. The radio
band is set from within the Radio Settings tab.
Lists the channel setting for the radio. Smart is the default setting. If set to
smart, the access point scans non-overlapping channels listening for beacons
from other access points. After the channels are scanned, it selects the
channel with the fewest access points. In the case of multiple access points
on the same channel, it will select the channel with the lowest average power
level.
Lists the transmit power for each radio.
Edit
Device Configuration 5 - 145
button to modify or override portions of its configuration.