Motorola Solutions WiNG 5.2.6 Reference Manual page 243

16.Refer to the following to determine whether a new Dynamic NAT configuration requires creation, edit or deletion:
Source List ACL
Network
Interface
Overload Type
NAT Pool
Overload IP
17.Select Add to create a new Dynamic NAT configuration,
to permanently remove a configuration.
Figure 5-99 Profile Overrides - Dynamic NAT screen
Lists an ACL name to define the packet selection criteria for the NAT
configuration. NAT is applied only on packets which match a rule defined
in the access-list. These addresses (once translated) are not exposed to the
outside world when the translation address is used to interact with the
remote destination.
Displays Inside or Outside NAT as the network direction for the dynamic
NAT configuration.
Lists the VLAN (between 1 - 4094) used as the communication medium
between the source and destination points within the NAT configuration.
Select the radio button to define the Overload Type used with the listed IP
ACL rule. Options include NAT Pool, One Global Address and Interface IP
Address. Interface IP Address is the default setting.
Displays the name of an existing NAT pool used with the dynamic NAT
configuration.
If One Global IP Address is selected as the Overload Type, define an IP
address used a filter address for the IP ACL rule.
Device Configuration 5 - 185
Edit to modify or override an existing configuration or Delete